DLab Thermo Control H100-Pro - Page 11

Speed, Time button respectively, the corresponding
characters will flash. Rotate the Adjustable knob to
set the parameters. If time is set to 00:00, it means
continuous working mode. After the setting
completed, push the adjustable knob to start
work.Refer to below figure.
Temp.
Speed
Timer
Set Acutal
30.5
1500
07:00
Prog.
Temp.
Speed
Timer
Set Actual
30.5
1500
07:00
30.5
800
06:59
RUN
Prog.
5.3.2 Multiple Step work without Saving
A．The program set in the single step is the
first step
by default. Refer to below figure.
Temp.
Speed
Timer
Set Actual
30.5
1500
07:00
1-1
Prog.
B．Push the Prog. button, start to set the second
step. The last line of in the Set column shows 1-
2 now. Refer to below figure.