this button, the time characters of
the setting area are flashing . In
timed working mode, the time
shows the countdown time. In
continuous working mode, the
time show running time. Refer
to below figure.
Mixing speed setting button, when
press this button, the speed
characters of the setting area are
flashing （Thermo mix models）
At parameter setting state, rotate
this knob can input values; When
finish the parameters setting, push
it to start work. At working state,
short push to pause; Long push to
stop working
5 Operation
5.1 Parameter setting methods
A. Respectively, press the function button,
the corresponding characters of the setting area are
flashing
B. Rotate parameter knob, input the target parameters.
C. Wait 3s, the corresponding character will stop
blinking, complete parameter setting.
Note: when power on, the setting area of the screen will
display parameters of the last run.
When the time is adjusted to 00:00, means the product
will run the continuous mode.
5.2 Start and Stop
1.Start: When finish the parameter input, push the
adjustable knob to start work. And in the last line in
the actual value area will display the characters
“Run”. Refer to below figure.
To Next Page
Loading...
