DLab Thermo Control H100-Pro - Running

Temp.
Speed
Timer
Prog.
Set
30.5
1500
07:00
Run
30.5
----
07:00
Actual
2. Pause: In the working state, short push the
adjustable knob to pause. Refer to below figure.
Temp.
Speed
Timer
Prog.
Set
30.5
1500
07:00
Pause
30.5
----
07:00
Actual
And in the last line in the actual value area will
display the characters “Pause”. When in this state,
only the timer and mixing functions are paused,
the temperature control function is still working.
(Thermal Control doesn’t support mixing function).
Resume: In the pause state, push the adjustable
knob, will resume to working state. And in the last
line in the actual value area will display the
characters “Run” again.
3. Stop: In the working state, long push the
adjustable knob to stop the current work.
Temp.
Speed
Timer
Prog.
Set
30.5
1500
07:00
Actual
(Thermal Control doesn’t support mixing
function). Refer to below figure.
5.3 Running
5.3.1 Single Step Work Without Saving
When power on, the screen shows the parameters of
the last run, or factory settings. Push the Temp,