CM170407AMA
the Status Screen (FIG 5) will flash with a black background to signal that the airspeed/Qc
is being limited due to the Mach number.
NOTE if the Mach number is displayed, it will flash on a red background instead.
CAUTION The Mach number limit is not enforced in Pt control mode.
6.3 ACOUSTIC ALARM FUNCTION
When the simulated (actual) values are almost at the commanded (target) values, an
acoustic alarm will start sounding (beep-beep) to warn the operator that the MPS49 is
approaching the target values.
The acoustic alarm function can be enabled or disabled from the Settings Menu, or by
pressing the SHIFT + 2 keys.
The tolerance values are around 10 feet altitude, 1 knot airspeed and 0.003 inHg AoA.
D.Marchiori Copyright 27
To Next Page
Loading...