CM170407AMA
SECTION 14 CALIBRATION
14.1 GENERAL
It is recommended that the MPS49 be calibrated at least once per year, preferably by an
ISO17025 accredited laboratory with a Best Measurement Uncertainty no greater than
± 0.01% of reading over the entire MPS49 sensor ranges.
Full details for carrying out the calibration of the MPS49 are to be found in the MPS49
Calibration and Adjustments Manual.
14.2 CALIBRATION SERVICE
In Italy, D. Marchiori s.r.l. maintain Accredia accredited calibration laboratory LAT No. 106,
guaranteeing low Uncertainties from the National Physical Laboratory for the Air Data
pressure range.
D. Marchiori s.r.l. specialise in the service and calibration of Air Data Test Sets and other
aerospace and meteorological instrumentation and will be happy to support your test
equipment.
D.Marchiori Copyright 51
To Next Page
Loading...