CellCom‑LTE‑V
Programming and Installation Guide Digital Monitoring Products
21
REMOTE OPTIONS
REMOTE OPTIONS
This option allows you to enter the information needed for remote command/remote
programming operation.
REMOTE KEY
Enter a code of up to eightdigits for use in verifying the authority of a receiver to perform
a remote command/programming session. The receiver must give the correct key to the
communicator before access will be granted. All communicators are shipped from the
factory with the remote key preset as blank.
To enter a new remote key, press any select area and enter any combination of up to
8digits. The numbers you enter appear as asterisks.
REMOTE DISARM
Choose YES to enable the communicator to be disarmed remotely. The default is YES.
Choose NO to disable remote disarming.
SYSTEM REPORTS
SYSTEM REPORTS
This option allows you to select which reports the
c
ommunicator sends to the receiver.
OPENING/CLOSING REPORTS
Choose NO to prevent sending opening/closing reports.
Choose YES to send opening/closing reports for each programmed area. The default is
YES.
ZONE RESTORAL REPORTS
Specify whether the communicator sends zone restoral reports and when they will be sent.
Choose NO to prevent sending restoral reports from the communicator.
Choose YES to enable the communicator to send zone restoral reports when a zone
restores from an alarm or trouble condition. The default is YES.
Note: The communicator sends zone restoral reports when a zone that has restored from
an alarm or trouble is disarmed. Twenty‑four hour zones send restorals immediately.
REMOTE OPTIONS
RMT KEY:
DISARM NO YES
SYSTEM REPORTS
O/C RPTS NO YES
RESTORAL
NO YES DISARM
To Next Page
Loading...
Need help?
General
