DOD Technologies ChemLogic 1 - 2.1.2 ChemLogic 1 & 2 Danger Zones

10
DC-ITD-CL1andCL2MAN01-2018.A www.dodtec.com
NOV 2018 815-788-5200
CL1 & CL2 Manual
WARNING:
Electric Shock is possible, please use caution when accessing this zone.
WARNING:
Moving Parts and Hand Crushing possible. Please watch hand placement when
working near this zone.
2.1.2 ChemLogic
®
1 & 2 Danger Zones
Please be aware of the following danger zones on the ChemLogic
®
1 and 2 continuous gas detection
equipment. Each zone contains warning labels for operator safety. Label meanings/descriptions can
be found in the above table.
A
WARNING:
This danger zone is located on the right side of the unit. It is the
warning for electrical shock in the following danger zone C.
B
WARNING:
This danger zone is located on the gate assembly. During
operation, operators could pinch fingers if not aware of
hand placement.
C
WARNING:
This danger zone is in the interior of the unit after zone A.
Operators could experience electric shock here if caution is
not exercised.
2.1.3 Maintenance Door
The maintenance door allows easy access to the ChemLogic
®
tape and the display/keypad. The latches on
the side of the unit are used to open & close/secure the door.