Chapter 6 – Maintenance
It is recommended for complete safety that the ChemLogic
®
1 & 2 continuous gas detection system be
serviced on-site every 6 months by a certified DOD Service Engineer or by submitting the unit to the
manufacturer for routine maintenance. A certificate of repair should be received and kept with operation
documents of the machine. Any malfunctions in the device should be reported and corrected before further
use.
For Permanent discontinuation:
Please contact DOD Technologies for the safe return of your equipment. All discontinued units will be
accepted back by DOD Technologies so proper recycling may take place. For information on how to return the
unit contact us using the below information:
6.1 Maintenance Door Access
The maintenance door is used to access the ChemLogic
®
tape and the display/keypad. To open the
maintenance door, release the middle latch on the side of the CL1/CL2 as shown in Figure 6.1. When
maintenance is complete be sure to close the maintenance door and secure the latch.
IMPORTANT: The maintenance door should always remain securely latched except when servicing the
ChemLogic tape or using the keys on the display
Figure 6.1
6.2 Service Door Access
DANGER: Service must be performed by trained personnel only. Turn off the unit, disconnect
A/C power and unplug the 14 pin I/O connector on the side of the unit (if installed) before
opening the Service Door.
To Next Page
Loading...