5.7.6 Clear History
The history screen contains the 128 most recent event, fault, and alarm messages. Each of the messages
logs the date/time occurred and the date/time cleared as separate entries. In the “Event/Alarm History” on
the Main Menu (Section 5.4.6) it is not possible to clear the history. By using this screen, the history may be
cleared if necessary. Use the same procedure used in the alarm and fault screens to clear the entries. Press
the soft key next to the arrow then press <F4> to clear. <ESC> will then bring back the screen in figure 5.28
and <ESC> again to return to the Service menu.
Figure 5.29
WARNING – Clearing the history log is not recommended. There is no way to recover the entries after they
have been cleared.
5.7.7 Configuration
The configuration menu is for certified service personnel only.
To Next Page
Loading...