32
DC-ITD-CL1andCL2MAN01-2018.A www.dodtec.com
NOV 2018 815-788-5200
Remove the top tape sleeve with the tape spooled around it by gently pulling away
from the machine.
Remove the old tape reel from the bottom spindle by lifting over the washer.
Discard the old tape & cassette appropriately
Remove the new tape reel from the protective packaging.
Pull the sleeve off the new tape reel and place the reel on the bottom spindle.
Place the new sleeve on the top reel.
Feed the new tape through the system as shown in figure 6.2
Verify the tape position on all rollers before proceeding.
Fold the end of the tape and loop it through the spool bar.
Backside image of tape fold and insertion under the spool bar.
Turn the top spindle a full turn to secure the tape
Press the gate button several times to make sure the tape is advancing properly.
To Next Page
Loading...