25
EN
VARC Chiller Controls Operation
6.3.7 Enabling Remote Control for Third-
Party Support
The Remote Support screen allows you to set up the
VARC for control by third-party technical support.
1. To display the Remote Support screen, from the Main
screen, tap Remote Support. See “Touch Screen” on
page 5.
2. To enable or disable remote support, tap the Enable
Remote Support button. (Default is enabled.)
20 Enable Remote Support Screen
3. In the MobileVNC Settings dialog box, on the
Control tab, press Start to begin remote login and
press Stop to finish.
21 MobileVNC Settings Dialog Box
4. Use the settings on the Advanced tab to select
configuration options for the remote login.
22 MobileVNC Settings Advanced Tab
6.4 Operating the LCD Screen
I
The following LCD instructions refer to the
PGD1 display. For the PLDPRO display, use the
corresponding buttons. See “PLDPRO LCD
Display” on page 4.
6.4.1 Understanding the Display Screens
The Main screen allows you to monitor single-stage
operation and additional stages in multi-stage operation.
The Main screen displays the following parameters:
a. Mode of operation (Econo or Normal)
b. Chilled water return temperature
c. Chilled water supply temperature
d. Condenser outlet temperature
I
The condenser outlet temperature is the freeze
control indicator for the condensers in heat mode.
Pressing the Scroll Down button moves through the
various parameters displayed on the LCD screen. In a
multi-stage configuration, you can scroll through the
parameters of the additional stages.
To Next Page
Loading...
Need help?
General
