20 EPT034331 Issue 5 May 2021
How to Clear a Blocked Nozzle
(1) Ensure the printer is in the idle state.
(2) On the TouchScreen, select Home > Setup > Wizards > Nozzle unblocking.
(3) Select Start Nozzle unblocking.
(4) Follow the on screen instructions.
WARNING: Hazardous chemicals. Risk of personal injury.
Wear protective equipment such as gloves and glasses when near the
printer. Physical contact with printer ink or make-up can cause skin or eye
damage.
CAUTION: Risk of poor print performance
Do not run the nozzle unblocking wizard more than 2 times. Each time the
wizard is run, the printer adds make-up to the ink. If the wizard is run too
many times, it may cause the viscosity of the ink to thin.
If the nozzle is not clear after 2 attempts, contact your local support office.
CAUTION: Risk of ink system contamination.
Do not attempt to remove the nozzle assembly (unless trained to do so).
Removing the nozzle assembly can cause contamination to enter the ink
system. The nozzle assembly is also tuned to the print head and will
require re-tuning if removed.
To Next Page
Loading...
Need help?
General
