DESCRIPTION
2-22 20509 Issue 7 Jan 2018
EXTERNAL CONNECTIONS
Product Detector and Shaft Encoder Connectors
(5-pin AXR)
There are three connectors SK1, SK2 and SK3. Connectors SK1 and SK3
are wired with the same connections so that a product detector can be
connected into either connector and a shaft encoder connected into the
other. Alternatively, SK1 and SK3 can be used to loop a single product
detector to another Macrojet 2 in an extended system. Where a second
product detector is used this must be connected into SK2. Pin connections
are given below:
Product Detector and Shaft Encoder Connections
Power Connector
Euroconnector with moulded lead:
•Line - brown
• Neutral - blue
• Ground - yellow/green.
Macrojet 2 must be connected to earth (ground).
SK1 SK2 SK3 Signal
1 1 1 0V
2 2 2 Shaft Encoder
3 - 3 Print Go 1
- 3 - Print Go 2
4 4 4 +5V
5 5 5 +12V
To Next Page
Loading...
