Fuse box
146
D760.H03E-001.H1907
2. Connect a hang:
a). Turn the latch spring upward and dial it
to the horizontal;
b). Pull the lever assembly outward and clip
the notch on the handle bar to the
bayonet on the edge of the saddle shell
(the traction seat is in the pre-hung
state);
c). Drive the tractor slowly backwards so
that the semi-trailer pin enters the
opening of the lock hook;
d). Pull pin pushes the lock hook to rotate,
and when the handle lever returns to its
original position, the lock card is
automatically reset and locked, that is,
the attachment is completed.
1. The position contacted with saddle
during connection process
1. Pre-hanging state: the handle bar is
stuck on the bayonet at the edge of
the saddle shell, and the lock car is
in a horizontal state
1. Completion status of the joint:
reset the handle lever, and seal
the v-shape with inclined wedge
1. Completion status:The lock pin is
automatically reset and locked at
the side of the handle lever
To Next Page
Loading...