Maintenance & Adjustment
D760.H03E-001.H1907 207
Saddle maintenance
Initial maintenance
Check the Maintenance period see "Main-
tenance and replacement items"
Add lubricating oil and grease to the sur-
face of saddle hook housing, wedge and arc
plate of saddle in 10,000km.
Maintenance interval
Check the Maintenance period see "Main-
tenance and replacement items"
Inspect Torque of hex bolt (measured with
torque wrench, torque value: 140-160Nm).
Check the Maintenance period see "Main-
tenance and replacement items"
Saddle No. 50# 90#
Inner surface wear limit
of open end cover (mm)
34.5~35.5 36.5~37.5
Innerl surface wear limit
dimension (mm)
51~55 89~93
1. lock hook
2. Open end cover
3. Surface of shell
4. Twist spring
5. wedge
1. Adjusting screw
2. Arc bearing plate
3. Split pin
1. Open end cover
A:wear on the inner surface
of the open-end cover
2. lock hook
B:wear amount on the inner
surface of the hook
CAUTION:
The open-end cover and lock hook
shall be replaced when they exceed
the limit size as above.
To Next Page
Loading...