Starting & Driving
154
D760.H03E-001.H1907
E and P gearshift mode
E: economic mode
P: power mode
It defaults the initial mode to E mode, and it
will change to P mode by pressing the switch,
and return to E mode by pressing the switch
again, and so on.
Note: E/P shown on the selection mode
instrument indicates operation of accelerator
pedal.
When depressing the accelerator pedal, it is required to adjust the accelerator
position flexibly based on road conditions and vehicle speed, avoiding fluctuation in
the speed which may increase fuel consumption during driving;
During automatic gearshift of the transmis-
sion, never release the accelerator pedal and
keep it stable;
Depress the accelerator pedal to a small or
medium extent as much as possible, and drive
at a constant speed, avoiding fast acceleration;
The transmission gearshift is selected by
TCU according to working conditions, while the driver can pay all attention on determi-
nation of road conditions and keeping driving at a constant speed.
Starting instructions
1. Pull up the hand brake to ensure that the rotary switch is turned to "N".
2. Start the engine, and do self-inspection on transmission prÂșCedures; afterwards,
"N" will be displayed.
3. When the rotary switch is turned to "D", it will automatically engage at START gear
(if necessary, the START gear can be corrected manually), at this time, the clutch
disengages.
4. Release the brake and depress the accelerator pedal (clutch engages) to start the
vehicle. When the accelerator pedal is not depressed, the vehicle will not run,
because the clutch under control of the transmission disengages.
Operation of accelerator pedal
Do not change the position of accelerator pedal during gearshift.
During gearshift, the working conditions of engine will be under control of output
signal from transmission shift actuator.
Operation of clutch release mechanism will be under control of transmission shift
actuator.
To Next Page
Loading...