Structure and Operation
76
D760.H03E-001.H1907
Automatic opening/closing sunroof
Press the opening switch to automatically
open the sunroof; Press the closing switch to
automatically close the sunroof.
Manual opening/closing sunroof
Press and hold the opening/closing switch:
the sunroof or the sunshade will begin to move,
and the time for movement depends on the
operation time of the switch.
The sunroof will stop moving when the
switch is released. Automatic closing of sunroof.
If the sunroof or the sunshade is at the
opening position, the sunroof can automatically
return to the initial closing status after the on-
board power supply is off for 5s.
Reset method of sunroof:
Operate the sunroof as follows: open the
sunshade, flip the glass up, and open the glass
outer slide rail and close it (no interruption is allowed during operation); when closing
is done in place, press and hold the closing button for 40-60s to realize automatic
learning and memorizing.
CAUTION:
1.With respect to the sunroof, the following circumstances may occur
due to powerful electromagnetic interference or other factors:
2.The sunroof moves for a short distance or does not move after the
closing button has been pressed, while the sunroof can make
progressive movement if the closing button is pressed and held;
3.The sunroof can move, but in disorder after the closing button has
been pressed or pressed and held;
4.The sunshade can close in place after the closing button has been
pressed;
5.The sunroof can automatically open after the key switch has been
turned off.
6.In case the circumstances above occur, please reset the sunroof; after
this operation, if the fault has not been eliminated, please operate the
sunroof and turn off the power key when the sunroof is operating, and
then turn on the key after 10s, and finally reset the sunroof. In case the
fault has not been eliminated, please drive your vehicle to the After-
sale Service Station of DONGFENG COMMERCIAL VEHICLE CO.,LTD.
for related inspection.
To Next Page
Loading...