1835-065-N-1-21
2
TABLE OF CONTENTS
3.5 Programming Phone Numbers and Names
3.5.1 Programming the Directory Code Length
3.5.2 Programming Directory Codes with 7-Digit Phone Number - NO Area Code
3.5.3 Programming Area Codes
3.5.4 Programming Directory Codes with Phone Numbers that use Area Codes
3.5.5 Programming Names - 1835 and 1837 Systems Only
3.5.6 Deleting Individual Phone Numbers
3.5.7 Delete Names - 1835 and 1837 Systems Only
3.5.8 Delete Area Codes
3.5.9 Delete phone Numbers - 1835 and 1837 Systems Only
3.5.10 PBX Line Access Code Programming
3.5.11 Touch-Tone Dial Pause
3.6 Programming Device Codes - 1833, 1835, 1837 Only
3.6.1 Programming Five-Digit Device Codes
3.6.2 Deleting Device Codes
3.6.3 Enabling Facility Codes
3.6.4 Programming Facility Codes
3.7 Programming Four-Digit Entry Codes
3.7.1 Programming Four-Digit Entry Codes
3.7.2 Delete Entry Codes
3.7.3 Entry Code Ranges
3.8 Anti-Pass Back
3.8.1 Programming the Anti-Pass Back Mode
3.8.2 Re-Sync All Devices
3.8.3 Re-Sync Individual Devices
3.8.4 Reset Facility Counter
SECTION 4 - ADJUSTMENTS
4.1 Speaker Volume, Microphone and Feedback
4.2 LCD Display Contrast - 1835 and 1837
4.3 Back-Lite Cutoff
4.4 Master Code Switch
4.5 Ring Pin Jumper
4.6 Relay 2 Jumper
4.7 Auto - 1816 Interface Jumper
4.8 HF - HS Jumper
SECTION 5 - SYSTEM OPERATING INSTRUCTIONS
5.1 Guest Instructions
5.2 Resident Instructions
5.2.1 Responding to a Guest Call
5.2.2 Using an Entry Code
5.3 System Administrator
5.3.1 Connecting to the Telephone Entry System from a Remote Location
5.3.2 Expansion Board Override HOLD OPEN Command
5.3.3 Relay Check
5.3.4 Time and Date Check
5.4 Miscellaneous Operating Instructions
5.4.1 Talk Time
5.4.2 Telephone Line Sharing
5.4.3 Connection to a PBX System
5.4.4 Areas with 10-Digit Dialing
5.4.5 Control Relays Directly from PC
SECTION 6 - MAINTENANCE
6.1 Troubleshooting
6.1.1 RS-232 Test
6.1.2 Wiegand Test - 1835 and 1837 Systems Only
6.1.3 Elevator Control Board(s) Hardware Test - 1835 and 1837 Systems Only
6.1.4 Elevator Board / Floor Hardware Test - 1835 and 1837 Systems Only
6.1.5 Automatic Hang-up Options - 1835 and 1837 Systems Only
6.1.6 Modem Output Level Adjustment
6.1.7 Display
DKS Data over IP Phone Number or System ID Number
6.1.8 Test Connection to
DKS Data over IP
6.1.9 Turn DKS Data over IP ON or OFF
6.2 Accessories
Wiring Schematics 1833, 1835 and 1837
SECTION 7 - LOG TABLES
7.1 Programming Information Tables
7.1.1 10 Area Codes
7.1.2 255 Area Codes
7.2 Resident Information
RESIDENT INSTRUCTION SHEET
43
44
44
45
45
45
46
46
47
47
47
47
48
48
48
48
48
49
49
49
49
50
50
50
50
50
51
52
52
52
52
53
53
53
53
54
54
55
55
55
56
56
56
56
56
57
57
57
57
57
57
58
58-59
60
60
60
61
61
61
62
62
62
63
64-66
67
67
67
68-69
70
71
System Keypad Programming when NOT using a PC
Testing
DKS Data
over IP
To Next Page
Loading...
Need help?
General
