Doran 360HD - Delete Sensor Location

To Next Page

To Previous Page

DORAN MFG. LLC  2851 Massachusetts Ave  Cincinnati, OH 45225  866-816-7233 

Doranmfg.com

1) Press the left or right arrow to select the words PSI, BAR, or KPA.

2) When you have selected the unit of measure, press the S button for three seconds

and the selection should blink twice and the beeper should beep twice to confirm the

selection in the monitor’s memory.

3) Press the P button to exit this mode and enter into the Delete Sensor Location mode

next. If you are done with the programming operation you can press the P button for

5 seconds and the monitor will return to the normal mode of operation. This can be

done in any section of the program mode when the programming is completed.

E. Delete Sensor Location

This step is only used when a sensor is to be removed from the memory of the monitor.

This would also be used to remove a sensor from one position and locate it to a different

position. If deleting a sensor is not necessary at this time, please see the second note

below:

NOTE: To enter directly into this program mode you will

need to press the P button for 5 seconds until the

“PROGRAM” is displayed. Then press the P button again

briefly 4 times to enter this mode (see Figure 2-20 for

screen display).

NOTE: To skip this section and go directly to the High Pressure Alarm Programming mode

just press the P button briefly 1 time. The display should look like Figure 2-23 or 2-24.

Anytime during this mode you can escape out to the next program mode by pressing the

P momentarily. If you want to return to the normal operation mode press and hold the P

button for 5 seconds.

The monitor will display the available sensors to delete and the words PROGRAM and

DELETE will be displayed on the screen (see Figure 2-20). If a sensor does not need to

be deleted you can just press the P button to go into the final program mode. If a sensor

will need to be deleted you will need to do the following steps:

1) Using the arrow keys select the desired sensor that

need to be deleted. The monitor will only display the

wheel positions that have a sensor programmed to

that position. When you select a position, the three-

digit number that was programmed will be displayed

Figure 2-20

ure 2-21