Doran 360HD - Programming the Unit of Measure

To Next Page

To Previous Page

DORAN MFG. LLC  2851 Massachusetts Ave  Cincinnati, OH 45225  866-816-7233 

Doranmfg.com

5) To adjust the minute (m) you will need to press and

hold the S button until the center digit flashes. You

will notice that the Month and Minute both use the

(M). Pressing the up and down arrow buttons will

adjust the value of this digit. When you have selected

the number that you want, press the right button to adjust the right digit in the same

manner with the up and down arrow buttons. When you have the proper number

displayed for the Minute (M) press and hold the S button for 3 seconds until the

monitor beeps and the display flashes twice. The display is shown like Figure 2-16.

6) This will bring you back to the (Y) years setting. Press the P button momentarily to

move to the Pressure Units Programming Mode (see Figure 2-17). If you are done

with the programming operation you can press the P button for 5 seconds and the

monitor will automatically return to the normal mode of operation. This can be done

in any section of the program mode when the programming is completed.

D. Programming the Unit of Measure

NOTE: To enter directly into this program mode you will

need to press the P button for 5 seconds until the

“PROGRAM” is displayed. Then press the P button again

briefly 3 times to enter this mode (see Figure 2-17 for

screen display).

NOTE: To skip this section and go directly to the Sensor Deletion mode just press the P

button briefly 1 time. The display should look like Figure 2-

20. Anytime during this mode you can escape out to the next

program mode by pressing the P momentarily.

The next step in the programming mode is to select the unit

of measure for the air pressure. The monitor is set from the

factory to read in PSI (pounds per square inch). This is the

default unit of measure. The monitor is also capable of

displaying the air pressure in BAR and KPA (see Figure 2-

18 and 19). If you want the monitor to read in PSI then nothing needs to be done except

to press the P button to move into the next section of the programming mode. To change

the unit of measure, do the following.

Figure 2-17

ure 2-18

ure 2-19

Figure 2-16

ure 2-19