DORAN MFG. LLC 2851 Massachusetts Ave Cincinnati, OH 45225 866-816-7233
Doranmfg.com
24
4. Backlight On for Night Operation
The backlight will automatically come on for any alarm or if you are viewing the wheel
positions in the normal operation mode. The light does not remain on in the normal
operation mode when “ON” is being displayed. To turn on the backlight press the S button
in normal mode and press it again to turn the backlight off.
VI. TECHS-N-TIPS
1. FREQUENTLY ASKED QUESTIONS
WHY DID I FAIL TO GET A SIGNAL FROM A SENSOR DURING INSTALLATION?
Higher radio frequency (RF) transmissions travel mostly via straight lines and along line-
of-sight pathways. The 360HD sensors are required to accomplish the difficult task of
transmitting a low power FCC approved signal from vehicle tires to the monitor. If a
sensor fails to be recognized, move the monitor slightly. The vehicle could be in what
is known as a “Dead Zone”, this is where the signal is not able to travel because of its
surroundings (pole barn siding, metal fence, side of a building). Moving the vehicle just
a few feet can sometimes overcome this problem. The sensor will need to be removed
and re-installed to activate the sensor for it to report quickly to the monitor. If you are
using an optional signal booster or remote antenna kit, reposition the booster or remote
antenna for a possible better reception.
WHY DOESN’T MY MONITOR TURN ON?
Check in-line fuse, replace if needed with a 2 amp fast-blow fuse. If you have hard wired
the system to the vehicle, be sure the ignition switch is on and check to see if either of
the fuses that were installed inline have blown. Replace all fuses with a 2-amp fast-
blow fuse.
HOW DO I MUTE THE AUDIBLE ALERT?
Press any button after the alert sounds. This will put the alert in the Quiet Mode. The
green light will have turned off, the alert will be displayed on the screen, and the
backlight will be lit. This will continue until the alarm has been corrected.
(Black box products don’t have audible alert or green light.)
WHAT IF THE GREEN LIGHT ON MONITOR DOES NOT LIGHT?
If the green light on monitor does not come on it will signify that something is not
correct with the settings that were inputted during setup to the monitor. Review the
information on the display and if a proper air pressure is being displayed be sure that
the baseline for the displayed wheel position was entered correctly.
(This is not for black box products.)
To Next Page
Loading...