DORAN MFG. LLC 2851 Massachusetts Ave Cincinnati, OH 45225 866-816-7233
Doranmfg.com
25
CAN THE MONITOR BE USED INDEPENDENTLY ON FRONT OR TOW
VEHICLE? Yes – See Drop and Hook Instruction PAGE 21.
CAN I STORE MY VEHICLE LONG TERM WITH THE MONITOR ON?
The monitor draws 60mA to 125 mA of power when it is under power and fully functional.
The monitor could drain vehicle's battery over an extended period of time. Hooking the
monitor up to enable the sleep mode will drastically reduce the power consumption over
a long period. If storing for over 3 months, you might consider unplugging the monitor
and removing the sensors for storage. (TIP: Clean egg cartons or plastic bags work
well for storing the sensors.) Each Sensor has its own serial number laser etched into
the cover. Be sure to enter these ID numbers in the diagram on page 7 so sensors can
be replaced on the same tire location when re-installing them, eliminating the need for
reprogramming. If a low-pressure alert is given while in storage, the sensor will alert
until the pressure is corrected and could dramatically affect the battery life of the
sensors. Sensors will shut down and stop transmitting when less than 5 lbs of air
pressure are present. When putting the system back on, power the monitor first, and
then screw sensors onto their original wheel locations. Pressure readings will display
within a few minutes on the monitor. Your 360HD system will now be active.
HOW DO I CHECK THE TIRE PRESSURES?
The pressures are updated to the 360HD Monitor every 8 minutes under normal
circumstances. With the monitor in Normal Mode, press the S button and then press
the arrow buttons in order to select a tire’s current pressure to display. When you have
finished your inspection simply press the S button again to return the monitor to the
normal mode.
WHAT HAPPENS WHEN I REMOVE THE SENSORS TO INFLATE OR CHECK THE
PRESSURE IN MY TIRES?
It is recommended that tire pressures be checked regularly using a quality pressure
gauge when the tires are at ambient temperatures. Remove the sensor, check pressure,
and inflate if necessary. When you return the sensor to the valve stem, the sensor will
begin to read the current pressure and return to its normal operation.
With the 360HD system you can air up a low tire with the tire being warm and replace
the sensor without worrying about the sensor giving a false alarm, unlike some of the
other systems available on the market.
HOW DO I DELETE A SENSOR?
See page 13 for full details on sensor deletion.
WHAT SHOULD BE DONE IF A LOW PRESSURE ALERT IS SOUNDED?
Immediately pull over and check low tire. Physically check tire and repair. Be sure to
check valve stem for damage. Soap stem to identify any leaks.
WHAT MAKES MY SYSTEM SENSORS TRANSMIT?
Sensors will transmit data to the monitor under the following conditions:
1) Sensors update with a signal every 8 minutes.
To Next Page
Loading...