Doran 360HD - Hot Warning Alarm; Normal Mode Accessory Functions; Drop and Hook Feature

DORAN MFG. LLC  2851 Massachusetts Ave  Cincinnati, OH 45225  866-816-7233 
Doranmfg.com
21
does not mean that the sensor is missing, just that a signal was not able to get to the
monitor. This could be from other signals interfering with the sensor signal, interference
from structures, or a poor signal. By FCC rules we must allow signals from other sources
to interfere with our signals. The DORAN 360 series sensors, as well as all the other
TMPS systems on the market are not allowed to interfere with other radio frequency (RF)
signals.
5. HOT WARNING ALARM
The HOT warning alarm is issued when the sensor senses a temperature that is greater
than 175℉ (80℃ ) around the sensor and could be signaling a suspension / wheel
component malfunction for that wheel position (see Figure 4-4). We have built into the
system this warning for tire safety and also the safety of the driver. With the sensor being
attached to the exterior of the wheel we believe that if the sensor sees the 175 ℉
temperature that there could be a malfunction to the
components of this wheel position.
We would expect a bad bearing or brake sticking in
this position causing the excess heat.
When the HOT warning appears, STOP and check your tire(s) as soon as safely
possible, and check for the possible cause.
NOTICE: A “LOW PRESSURE” warning will over-ride a “HOT” warning because of
the potential danger of a low pressure tire.
V. NORMAL MODE ACCESSORY FUNCTIONS
1. Drop and Hook Feature
This feature allows the operator of the vehicle to drop the monitoring of either the front
or the rear vehicle allowing the monitor to only receive the RF signals from the vehicle
that is in close proximity to the monitor.
The operator can drop the trailer and still monitor
Figure 4-4