Doran 360HD - Programming the Date and Time for Stored Alarm History Information

DORAN MFG. LLC  2851 Massachusetts Ave  Cincinnati, OH 45225  866-816-7233 
Doranmfg.com
11
3) Press the left or right arrow button to select the next digit. Use the up and down arrow
buttons to change that digit. When you have entered the number that you want, press
the S button for 3 seconds until the number flashes twice and a double beep is heard
to signify that the number has been locked into the monitor’s memory.
After enter the number that you want, to press S and P simultaneously for 3
seconds will set the number as the baseline pressure for all the tires in the monitor.
4) A new position will be highlighted to input a baseline air pressure. If you wish to
program another sensor repeat the steps 1 thru 3. If you have completed the sensor
baseline air pressure programming sequence then you can press the P button
momentarily to move to the Time and Date setting mode. If you are done with the
programming operation you can press the P button for 5 seconds and the monitor will
automatically return to the normal mode of operation. This can be done in any section
of the program mode when the programming is completed.
C. Programming the Date and Time for Stored Alarm History
Information
NOTE: To enter directly into this program mode you will need
to press the P button for 5 seconds until the “PROGRAM” is
displayed. Then press the P button again briefly 2 times to
enter this mode (see Figure 2- 10 for screen display).
NOTE: to skip this section and go directly to the
Programming the Units of Measure just press the P button
briefly 1 time. The display should look like Figure 2-17.
Anytime during this mode you can escape out to the next
program mode by pressing the P momentarily.
1) The first thing that you will adjust is the Year (Y).
Pressing the S button for 3 seconds will cause the
center digit after the Y to flash (see Figure 2-11).
This should remain a 0 until the year 2010, and then
it will be changed to a 1 for 2010. Pressing the up
and down arrow buttons will adjust the value of this digit. When you have selected
the number that you want, press the right button to adjust the right digit in the same
Figure 2-10
Fi
g
ure 2-11
Fi
g
ure 2-12