Dormakaba ED50 - Appendix A - Driving Parameters; Driving Parameters - Detail

54
ED50/ED100/ED250 09-2021DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Opening speed, automatic mode

ED
- *
°/s

ED: low energy only.
*ED adjustable opening speed range.
ED/ED
Full adjustable range of opening speeds available only when configured for full energy
(Parameter F).
**Maximum opening speed reduced to °/s in low energy mode.
. After adjustment, internal monitoring system checks if parameter setting is
admissible. If setting exceeds admissible value, the setting is alternately displayed
with the permissible value.
. After adjustment, Internal monitoring system checks if parameter setting is
admissible. If setting exceeds admissible value, the setting is alternately displayed
with the permissible value.
. After parameter set, verify setting meets ANSI/BHMA standards
A. (full energy) or A. (low energy) standards. Reference Chapter .
ED
- **
°/s
ED
 - **
°/s
Closing speed, automatic mode

ED
- *
°/s

ED: low energy only.
*ED adjustable closing speed range.
ED/ED
Full adjustable range of closing speeds available only when configured for full energy
(Parameter F).
**Maximum closing speed reduced to °/s in low energy mode.
. After adjustment, internal monitoring system checks if parameter setting is
admissible. If setting exceeds admissible value, the setting is alternately displayed
with the permissible value.
. After adjustment, Internal monitoring system checks if parameter setting is
admissible. If setting exceeds admissible value, the setting is alternately displayed
with the permissible value.
. After parameter set, verify setting meets ANSI/BHMA standards
A. (full energy) or A. (low energy) standards. Reference Chapter .
ED
- **
°/s
ED
 - **
°/s
Hold open time, automatic mode
• Hold open time starts once all internal, external, safety and push and go inputs have
been opened or dropped, and door is in an open position; Hold open time can be
re-triggered.
• Hold open time values from  to  are set in increments of  second.
• *Parameter F, when set to full energy, extends maximum hold open time to 
seconds.
• Hold open time values greater than  seconds are set in increments of  seconds.

 -  s

 - * s
Appendix A - Driving parameters
A. Driving parameters – detail
A.. Driving parameters detail.