Dormakaba PORTEO - Product description; General; Functionality; Low energy product

4 PORTEO
2021-03WN 060008 45532
dormakaba Mounting instructions Product description
Special protection requirements with regard
to particularly vulnerable people
Insofar as the risk assessment results in an
unacceptable impact for a door user, in
terms of a health risk or a risk of injury,
protection must be added in the form of a
safety device (connection of a sensor strip).
This is to be taken into special consideration
if particularly vulnerable persons (e.g.
children, elderly people or disabled people)
use the door area.
2.3 Danger points
Depending on the structural condition, door
variant and protection option, residual risks
exist (e.g. crushing, force limited impacts).
Any suitable jam protection (e.g. rubber or
textile cover) is available in specialist shops
and is not included in the scope of delivery.
3 Product description
The PORTEO is an electromechanical
operator for opening and closing swing
doors indoors.
3.1 General
The PORTEO is preset for a variety of
applications (default setting).
The direction of rotation, door weight, door
width, mounting type, door closed position
and door open position parameters
determine the smooth and faultless door
operation.
A number of parameters are included in the
default settings, other parameters need to
be determined and some are automatically
determined during a learning cycle.
3.2 Functionality
The PORTEO can automatically open and
close doors. The opening is triggered by a
pulse, for example, by pressing a button. The
motion of the drive is transmitted to the
door by the slide rail or the scissor arm.
Once the hold-open time elapses, the door
closes again. Alternatively, the PORTEO can
also be operated manually without buttons.
The manual opening of the door is then
supported by the drive. The closing process
is automatic.
ATTENTION
Risk of damage to the operator
due to blocked door. When using
electrical activators, it must be
ensured that an electrical door
opener releases the door.
3.3 Low energy product
The PORTEO can be set in such a way that
the requirements of a low energy application
(Low Energy Operator) according to
EN16005 or DIN18650, ANSI156.19 and
BS7036-4 are met. During commissioning,
the operator parameters must be compared
with the specifications of the currently valid
standard. Due to system tolerances,
following the automatic learning cycle the
actual forces on the door leaf need to be
measured and, if necessary, accordingly
changed to meet local
standards and regulations.
The required safety of the unit is achieved by
the following characteristics:
• Reduced dynamic door leaf/contact forces
• Low travel speeds
• Reduced static door leaf/contact forces
• Force limitation
The use of additional safety sensors to
provide protection against rotary movement
is not mandatory, but can be used as an
option if this is necessary due to the risk
assessment being performed on an
individual basis. Protection of the secondary
closing edge must be considered on a
separate basis.