Dormakaba PORTEO - Mounting; Safety during mounting; Mounting types; Preparing mounting on site

8 PORTEO
2021-03WN 060008 45532
dormakaba Mounting instructions Mounting
4 Mounting
The individual mounting steps are illustrated
in the figure part of the manual. The figures
in the figure part of the manual show the
mounting at a right-opening door with
hinges on the left side (DIN left). For a
left-opening door with hinges on the right
side (DIN right), the instructions must be
mirror-inverted.
4.1 Safety during mounting
• Secure workplace against unauthorized
entry. Falling parts or tools can cause
injury.
• The PORTEO must be protected against
water and other liquids.
• The fastening type and fastening
materials, such as screws and dowels,
must be adjusted to structural conditions.
• Prior to installing the PORTEO, check that
the door leaf is in good mechanical order
and moves easily.
• The mounting of the PORTEO described
here is an example. Structural or local
conditions, existing aids or other
circumstances may make a different
approach sensible.
• Following mounting, the settings and
functioning of the PORTEO are to be
checked and the safety devices with
regard to their good mechanical order.
• Only qualified specialists may open the
mains connection housing.
• Prior to removing the protection cover,
disconnect the PORTEO from the power
supply.
4.2 Mounting types
Various mounting types are possible.
Additional components are required
depending on the mounting type.
Lintel mounting
Standard mounting type with swing door
operator on the lintel and slide rail on the
door leaf. If the swing door operator is
mounted on the opposite hinge side, at lintel
depths greater than 30 mm a scissor arm
(option) must be used.
Door leaf mounting
ATTENTION
In the case of door leaf
mounting, the power cable must
be protected against crushing.
Use the concealed cable loop.
Mounting type with the swing door operator
on the door leaf and the slide rail on the
door lintel.
4.3 Preparing mounting on site
5
1. Disconnect system from power supply
(remove fuse).
2. Prepare the power cables and optional
control cables on site.
3. Mount optional mounting plates.
4. Mount the mounting plate.
5. Prepare and mount slide rail with fixing
pieces.
4.4 Mounting
6 Preparing the operator
Dismantle the mains plug. This step is not
needed if the power cable is used.