Dormakaba PORTEO - Operation; Operation modes;functions; Switch position I PowerMotion; PowerLess operation mode

13PORTEO
2021-03WN 060008 45532
dormakaba Mounting instructions Operation
7 Operation
7.1 Operation modes/functions
1. Switch power switch to “ON” position.
2. Move the program switch to the desired
switch position.
7.2 Switch positions 0
The operator does not function in the 0
switch position.
→ The door can be manually opened.
7.3 Switch position I
“PowerMotion”
When in the “PowerMotion” switch position,
the opening and closing cycles are triggered
by activators (e.g. buttons, radio control or
transponders), if necessary, an electrical
door opener may be required.
→ When a pulse is triggered, the door
moves to the “Open” position and
closes automatically once the preset
hold-open time elapses (5 sec. to 30
sec.).
Note
If an opening pulse is triggered
during the hold-open time (door
is in “Open” position), the set
hold-open time is restarted.
Note
Before actuating the program
switch, ensure that the door is
not closed
or locked. Otherwise, the door
cannot move out of the “Closed”
position.
Depending on parameterization, the
“PowerLess” switch setting can be operated
with two extended operation modes
“PowerLess” and “Push&Go” (see 3.6).
7.3.1 “PowerLess” operation mode
In “PowerLess” operation mode, the door
can be opened manually with minimal effort.
The “PowerLess” function is set with
potentiometer 1, see 3.6.
Opens the door manually, the motion is
supported by the operator. Once the
hold-open time elapses, the door closes
automatically.
7.3.2 “Push&Go” operation mode
Potentiometer 1 (see 3.4) must not be in the
“PowerLess” position.
The “Push&Go” function is permanently
active in “PowerMotion” mode.
In “Push&Go” operation mode, the opening
pulse is triggered by a manual movement of
the door (opening with door handle) by
approx. 3°:
‣ The door moves to the “Open” position
and closes automatically once the
hold-open time elapses.
→ When a further opening pulse is
triggered during the closing cycle (the
door is opened against its swing
direction), the door travels back to the
set “Open” position and closes
automatically once the set hold-open
time elapses.