14 PORTEO
2021-03WN 060008 45532
dormakaba Mounting instructions Operation
7.3.2.1 Obstacle detection
During the opening movement
If the door meets an obstacle during the
opening movement, the opening movement
is immediately stopped. After approx. 3 sec.
the door restarts an opening movement. If
the door meets an obstacle more than three
times when moving to the Open position,
the door moves back to the “Door closed”
position.
→ This process is repeated for each
opening pulse until the obstacle has
been removed.
During the closing movement
If the door meets an obstacle during the
closing movement, the closing movement is
immediately stopped.
‣ The door remains stopped by the
obstacle. After a few seconds, the door
moves several degrees in the “Open”
direction. Following a waiting time, the
door tries to close once again. This
process is repeated three times, the
door then stops by the obstacle and
remains there.
→ By manually moving the door in the
“Open” or “Close” direction by approx.
3°, the door automatically continues
moving in the specified direction.
7.3.2.2 Vandalism mode
The PORTEO has a vandalism mode.
In case the door is pressed against its
original driving direction during an opening
or closing cycle, the gear is disabled (the
door can be operated manually).
After around 5 seconds the door
automatically returns to the adjusted
function program.
7.3.2.3 End stop
The end stop accelerates the closing speed
when the door reaches the last few degrees
before it closes in order to overcome air
resistance, the closing resistance of the
latch and the friction caused by door
sealings. The end stop is deactivated on
delivery. For adjusting the end stop, see 5.3.
7.3.2.4 Blocking detection
If an opening signal is generated at a locked
door, the door moves once against the door
lock and turns off. Another opening signal is
ignored for 5 sec. By manually moving the
door in the “Open” direction, the door opens
and continues in the set operation mode.
7.4 Switch position II
“PermanentOpen”
(permanently open)
When in the “PermanentOpen” position, the
door travels to open position and remains in
this position, until another operation mode
is set with the aid of the program switch.
→ Option
"PermanentOpen" with surge current
function, in the "PowerMotion"
program switch position with button or
hand-held remote control as activator.
Press button twice in short succession
or press the programmed pushbutton
on the hand-held transmitter once:
→ the door travels to the "Open" position
and remains in this position. The door
closes as soon as the button is pressed
again twice in short succession or the
programmed button on the hand-held
transmitter is activated once again.
To Next Page
Loading...
