Faults -6
Version 1.36
02/2004
Water leakage - rear side of the dispense area (drip tray)
Cause Action Ref.
1. Water from the inner cover Water is leaking from the inlet assembly, water tank or 5A-7 / 5A-8
flows into the drip tray. inlet valve (fixed water connection) and flows into the PL-2
inner cover. Check/replace defective/won parts.
Check the opening in the upper rear corner of the
dispense area for traces of scale.
Water leakage - Machine right side.
Cause Action Ref.
1. Water tank is damaged Check and replace if necessary. Water leakage will not 5A-8
(cracked) or the tank valve be confined to the right side only. PL-9 / PL-10
leaks.
2. Condensation in cooling Condensated water is partly guided by the frame
compartment (bridge) through the wiring opening to the right side and
reaches the machine base behind the main switch. 5F-5
Check cooling compartment door and sealing. PL-6 / PL-7
Water leakage - Machine front side.
Cause Action Ref.
1. Excessive condensation in Check if the cooling compartment door is properly
cooling compartment. closing. Correct and/or replace worn/defective 5F-5
(cold coffee pack) parts. PL-6 / PL-7
Water remains dripping out of the trough
Cause Action Ref.
1. Product valve leaks. (does Check and replace the valve(s). 5A-6 / PL-3
not close due to scale
deposit)
To Next Page
Loading...
