26 TOW-BEHIND DR
®
FIELD and BRUSH MOWER
Slopes and Uneven Terrain
• CHECK THE OWNER’S MANUAL FOR YOUR TOW VEHICLE TO DETERMINE ITS RECOMMENDED
TOWING CAPABILITIES ON SLOPES.
• WHEN OPERATING THE TOW-BEHIND DR FIELD AND BRUSH MOWER OVER UNEVEN TERRAIN OR
SLOPES, USE EXTREME CAUTION NOT TO TIP OVER THE MACHINE.
• NEVER USE THE TOW-BEHIND DR FIELD AND BRUSH MOWER ON SLOPES GREATER THAN 20
DEGREES. DOING SO COULD RESULT IN SERIOUS INJURY OR DAMAGE TO YOUR MACHINE.
• IF YOU HAVE TO MOW ON SLOPING TERRAIN, MOW UP AND DOWN, NEVER ACROSS THE SLOPE,
FOR BETTER CONTROL.
If the machine gets hung up
1. Disengage the Blades and STOP the Engine. NEVER try to free the machine from stumps or debris
with the Blades engaged.
2. Try driving over or backing away from the obstacle.
• IF YOU NEED TO LEAVE THE TOW VEHICLE TO CLEAR DEBRIS FROM THE MOWER DECK, SET THE
PARKING BRAKE AND SHUT OFF THE TOW VEHICLE ENGINE, DISENGAGE THE MOWER BLADES, SHUT
OFF THE TOW-BEHIND DR FIELD AND BRUSH MOWER ENGINE AND DISCONNECT THE SPARK PLUG
WIRE(S).
• NEVER TOUCH THE EXHAUST AREAS WHEN REACHING FOR THE SPARK PLUGS; THEY ARE VERY HOT.
Cutting Brush and Saplings
1. The cutting capacity is 1-1/2" saplings.
2. When cutting woody material, small saplings, etc., allow the machine to ride up and over material
slowly. Adjust your forward speed to varying conditions.
3. After cutting brush, etc., you may want to mow over it again to remove any remaining branches. It
works best to mow from the trunk end toward the top as brush lies on the ground.
4. If you are using Offset Mowing, keep the Offset at 75% when cutting heavy brush. See page 25.
Cutting Wet and Heavy Growth
1. Avoid steep slopes and other slippery areas.
2. Use a lower, slower speed when mowing in wet conditions.
To Next Page
Loading...
