DR ROTO-HOG - CHAPTER 5 MAINTAINING THE OPTIONAL ACCESSORY; Maintaining the DR Power Spreader; Regular Maintenance Check List before each use; Cleaning

CALL TOLL FREE 1-800-DR-OWNER 23
CHAPTER 5
MAINTAINING THE OPTIONAL ACCESSORY
Regular maintenance is the way to ensure the best performance and long life of your OPTIONAL
ACCESSORY. Please refer to this manual for maintenance procedures.
MAINTAINING THE DR POWER SPREADER
Regular Maintenance Check List before each use
CHECK FOR LOOSE FASTENERS
1. Before each use make a thorough visual check of the Spreader for any bolts and nuts which may
have loosened. Retighten any loose bolts and nuts.
CHECK FOR WORN OF DAMAGED PARTS
1. Check for worn or damaged parts before each use.
2. Repair or replace parts if necessary.
CLEANING
1. Rinse inside of Hopper and exterior of Spreader and dry off before storing (even though the
Spreader Motor is sealed, avoid spraying the Motor and wires if possible).
2. Clean out any build up of material from the Hopper Closure Plate.
3. Clean any build up of material from your ROTO-HOG Tiller.
Storage
1. Rinse inside of Hopper and exterior of Spreader and dry off before storing (even though the
Spreader Motor is sealed, avoid spraying the Motor and wires if possible).
2. Store in a clean, dry area.
WHEN PERFORMING ANY MAINTENANCE ON THE DR SPREADER ATTACHMENT WHEN THE UNIT IS
STILL ATTACHED TO THE TILLER, YOU MUST FIRST MAKE SURE THE SWITCH ON THE TILLER CONTROL
BOX IS IN THE “OFF” POSITION AND THEN DISCONNECT THE WIRE HARNESS OF THE MOTOR
M
OU
NT A
SS
EMBLY
.
FOLLOW ALL WARNINGS, CAUTIONS ETC. FROM THE MATERIAL MANUFACTURERS FOR PROPPER
CLEANING AND DISPOSAL PRACTICES BEFORE CLEANING YOUR EQUIPMENT.