Instructions for use | Atlan A300, A300 XL, A350, A350 XL SW 1.0n 115
Operation
7.7.5 Displaying an overview of accessories and consumptions
1. Open the System setup dialog.
2. Touch the System status tab.
At Standby > System setup > System status > Consumption the gas
consumption levels can be reset to zero, see page 180.
7.8 Setting the volume
1. Open the System setup dialog.
2. CAUTION
Risk of an operating error
During operation in louder environments, the acoustic alarm signals might not be
heard.
► Always set the alarm tone to be sufficiently loud.
Touch the System > Sound volume tab (1).
3. For Alarm volume (2), set the desired value.
Vertical tab Overview
Accessories Accessories (when Dräger Infinity ID accessories are
used) and information as to when the accessory must
be replaced.
Supply Status display of the connected gas supplies and
power supplies
Consumption Gas consumptions during operation:
– For the current case
Gas consumptions in Standby:
– For the last case
– Since the last reset
35918
2
1
1
To Next Page
Loading...
