Instructions for use | Atlan A300, A300 XL, A350, A350 XL SW 1.0n 7
Information about this document
1 Information about this document
1.1 Typographical conventions
1.2 Use of terms
Dräger uses the term "accessories" not only for accessories in the sense of
IEC 60601-1, but also for consumables, removable parts, and attached parts.
The product "Atlan A300, A300 XL, A350, A350 XL" is also referred to as "Atlan".
1.3 Illustrations
Illustrations of products and screen content in this document may differ from the
actual products depending on configuration and design.
1.4 Trademarks
1.4.1 Trademarks owned by Dräger
Text Bold, italicized text indicates labels on the device and screen text.
1. Numbers with a period indicate the individual steps within a process
sequence. The numbering for each new process sequence starts once
more at number 1.
a. Lower-case letters with a period indicate secondary process steps. The let-
tering for each new higher-level process step starts once more with the
letter a.
► This triangle indicates individual steps without any specific order.
(1) Numbers in parentheses refer to elements in illustrations.
1 Numbers in illustrations denote elements referred to in the text.
– Dashes indicate listings.
> The greater-than symbol indicates the navigation path in a dialog.
This symbol indicates information that will facilitate the use of the product.
Trademark
Atlan
®
AutoFlow
®
Infinity
®
D-Vapor
®
Drägersorb
®
MEDIBUS
®
ServiceConnect
®
WaterLock
®
To Next Page
Loading...
Need help?
General
