Instructions for use BiliLux 63
Reprocessing
1 Remove soiling immediately. Use a cloth dampened with disinfectant to remove
soiling.
2 Perform surface disinfection of all device surfaces: thoroughly wipe the product
3 times. Observe the recommended contact time specified by the disinfectant
manufacturer.
3 After the product has been exposed to the disinfectant for the specified contact
time, remove residual disinfectant.
4 Wipe with a cloth dampened with water (preferably drinking-water quality). Allow
the product to dry.
5 Check the product for visible soiling. Repeat steps 1 to 5 if necessary.
6 Check the product for visible damage and replace if necessary.
11.6 After reprocessing
11.6.1 Assembling the components
CAUTION
Risk of injury or damage to the device
If the device is assembled incorrectly, or parts/assemblies are not reinstalled after
cleaning or maintenance, the essential performance and/or basic safety of the
device may be compromised.
► Assemble the device according to the instructions for use.
Inspect all reprocessed components for any breakage or cracks before
reassembling into the device.
11.7 Preparations before reuse
1 Assemble and prepare the device so that it is ready for use, see chapter
"Assembly and preparation".
2 Check the operational readiness, see chapter "Getting started".
3 Perform a complete functional check before returning the device to service, see
"Functional check procedure" on page 38.
To Next Page
Loading...
Need help?
General
