30 Reprocessing instructions | Perseus A500
Reprocessing
Performing reprocessing
1. Select a cycle.
2. When the cycle has ended, check the components for visible soiling and repeat
the cycle if necessary.
3. Check the components for visible damage and replace if necessary.
Supplementary information
● If no TurboVent 2 blower module is being used, fix the cap (A) on the holder (B).
3.5.4 Special reprocessing measures
Drying the components
● Allow all the components to dry completely.
Proceed as follows with the TurboVent 2 blower module:
1. Carefully remove any residual fluid that may be present in the blower module.
2. Allow the blower module (A) to dry with the openings facing downward.
The following procedures are possible:
– Place the blower module in a drying cabinet at 60 °C (140 °F) for 3 hours.
– Allow the blower module to dry at room temperature for 24 hours, preferably
on a mesh. The mesh will enable air to circulate.
3910239346
To Next Page
Loading...
