Need help?Do you have a question about the Dräger Polytron FX and is the answer not in the manual?
General| Measurement Principle | Electrochemical |
|---|---|
| Gas Detected | Depends on sensor type |
| Measuring Range | Varies by gas type |
| Response Time | T90 < 15 seconds |
| Communication | 4-20 mA, HART, RS-485, Modbus |
| Protection Class/Rating | IP66/67 |
| Housing Material | Stainless steel |
| Output Signal | 4-20 mA |
| Certifications | ATEX, IECEx, UL, CSA |
Emphasizes adherence to manual for safe instrument assembly and installation.
Details requirements for use in explosion-prone areas, sensor installation, and component modifications.
Covers warranty periods for instrument/sensor and liability for damage from improper servicing.
Outlines the step-by-step process for safely replacing the sensor, including declassification and power precautions.
Outlines the general procedure for calibrating the unit, including specific steps for DraegerSensor IR and PR/LC.
Details the process for performing a zero calibration, including gas application and adjustment using the menu.
Explains how to perform a span calibration, emphasizing prior zero adjustment and gas application.
Lists common error codes, their conditions, and suggested solutions for troubleshooting.
To Next Page