Dräger Primus - Displaying and setting alarm limits

Alarms
Suppressed alarm limits are identified by
the symbol » YE « in the parameter field.
National and European standards
require a minimum monitoring with
some alarm functions. These
standards may not be met if the alarm
function of the SpO2 monitoring
parameter is disabled.
Displaying and setting alarm
limits
Alarms can be displayed and set from all
three basic screens (standard, data and
trend screens) during operation.
There are standard alarm limits
configured for the ventilation modes
which may be used, as is, see "Setting
alarm limits" on page 111 or adjusted
individuaily for the patient concerned.
For this purpose, the alarm limits menu
can be selected in standby via the soft
key »alarm limits«.
To call up alarm limits during operation:
© Press the soft key »alarm limits«.
Display (example):
The current measured values and their
alarm limits are grouped on the right.
Volume
The curves with the alarm limits
represented by dashed lines are
displayed on the left.
Example etC02:
The upper alarm limit (50 mmHg) and
lower alarm limit (30 mmHg) are shown
alongside the measured value
(38 mmHg).
A disabled alarm limit is indicated by two
dashes (- -).
100
Instructions for Use Primus SW 2.n