Dräger Primus - SpO2 alarms on;off (optional)

@ CO2 apnoea and pressure apnoea
alarms are inactive.
© SpO2 monitoring alarms are inactive.
The HLM mode can be used in ail active
ventilation modes.
HLM mode on/off
To activate/deactivate HLM mode in an
active ventilation mode:
@ Press the soft key »config.« on the
standard or data screen.
@ Select and confirm the column
»alarms on/off« via the rotary knob.
@ Select and confirm the line
»HLM modes via the rotary knob.
© Select and confirm »on« or »offe via
the rotary knob.
The HLM mode remains activated when
changing ventilation modes; it is
deactivated when changing to standby.
Deactivating the HLM mode immediately
reactivates the CO2 alarms, but SpO2
measurement (optional) is only
reactivated when pulse signals have
been detected again.
Deactivating the HLM mode has no
effect on the "ON" or "OFF" status of
SpO2 measurement; the last status set
is retained.
SpOz alarms on/off (optional)
To enable/disabie all SpO2 alarms.
SpO2 alarms can also be enabled and
disabled during operation via »alarms
on/off« in the configuration screen,
page 120.
e Select and confirm »SpO2 on« or
»SpO2 off« via the rotary knob.
Instructions for Use Primus SW 2.n
Volume
Alarms
9 9 s
u u u “ο coz
7 7 7 on oof volumes)
6 $ 6 alarms
s s s HiMmode ὁ
4 4 4 m
3 3 3 spo;
2 2 2
4 4 1 an on
5 n
eel
Use © to activate a submenu.
FRESH GAS "BER 1:19 ‘Triggers ΟΕΕ
0081
99