Dräger Primus User Manual

Getting started
Getting started
Checking the workstation
according to the check list
Preconditions:
The workstation must be prepared as
described, "Hygiene and care" on
page 128 to page 139 and assembled
ready for operation as described from
"Assembly" on page 140 to page 144.
The gas supply and power supply must
be connected.
Power on
1 Switch on Primus: press the power
switch » må Om «an acoustic tone
sounds.
After approx. 15 seconds, all LEDs
and the loudspeaker are tested by
Primus.
The initial screen appears after approx.
20 seconds. Primus now loads its
software and tests its internal memory.
The check list is displayed after about
35 seconds.
@ Check the components as instructed
in the check list on the screen.
if the self test has to be interrupted, e.g.
for a quick start in an emergency:
@ Press the »cancel test« key. See
"Emergency start", page 42.
Cancelling the self test may lead to
limited functionality or failure.
Greater attention is required during
operation if the self test has been
interrupted.
34
Primus
LLL a
U
соо 000
CC
O O
υπ
Breathing Circuit
ey rating dağ 이
1 Press © to start the self test,
or press “cancel test” for
; emergency operation.
Instructions for Use Primus SW 2.n
uni
0013
0013

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup