Dräger Primus - Page 38

Getting started
WaterLock water trap
@ Check filling level in water trap.
When the level reaches the mark:
@ Pull the water trap out of its holder and empty it.
@ Insert an empty syringe without canula, at least 20 mL, into
the connector.
Extract water, remove syringe and dispose of full syringe
with ordinary domestic waste.
e Slide the water trap back into its holder — until it engages
tangibly.
The water trap must not be used in combination with
a medication nebulizer!
See page 147 for additional information on using the water
trap.
Preparing Primus for the self test
1 Close the Y-piece = plug firmly onto the cone.
2 Ensure that the sample line is connected to the Y-piece and
to the water trap.
3 Set APL valve to position »MÁN« and to 30 mbar.
38
Ll
uni
0020
|
υπὶ
0021
Instructions for Use Primus SW 2.n
ni
6002
|