Dräger Primus - Emergency start

Getting started
Emergency start
This procedure should only be used in
emergency situations!
—
Switch on the workstation.
© Check that both vaporisers are
closed.
2 Set »Safety O2< knob for O2
emergency flow to the required O2
flow, between 0 and 12 L/min.
© Start manuai ventilation.
@ Wait for the software to be internally
loaded and for the electronics to be
tested. The check list appears after
about 35 seconds.
Display:
3 Press the soft key »cancel test«.
The device only runs through a
minimal self test for about
10 seconds. Manual ventilation is
interrupted for this time, but
spontaneous breathing can continue.
Primus is ready for operation about
1 minute after initiating. The O2 sensor
is completely calibrated after about
2 minutes.
The leakage and compliance test is not
performed. The accuracy levels
specified in the chapter "Technical data"
cannot be guaranteed.
To prevent abuse of this feature, the
self test can only be cancelled ten
times in succession.
After ten cancellations, the self test
cannot be cancelled the next time that
Primus is started and a complete self
test must be carried out.
Cancelling a test can lead to limited
@ Greater attention is required
during operation.
The workstation switches to the standby
mode after completing the minimal self
test.
To start Primus:
@ Turn the O2-safety knob for
emergency metering to O and press
it.
Select the fresh-gas setting and
ventilation mode, see "Operation",
page 46.
42
Primus
し し し し し し し し し し し し
seo voa (δι
5 O 9 a |
CE
1
LL]
ーー
| Pross ® to start the self test,
. or press “cancel test” for
emergency operation.
uni
0023
0019
Instructions for Use Primus SW 2.n