Dräger REGARD-1 - For your safety; Maintenance and Safety Procedures; Explosion Hazard Warning; Liability for Proper Function

For your safety
Issue 5 - June 2005 Page 7 of 64 Pages
For your safety
NOTE
Observe the instructions for use
Follow the instructions for installation, operation and
maintenance.
maintenance
The device must be inspected and serviced regularly by trained personnel. Keep a
record of inspections and servicing.
Repairs of this device may only be carried out by competent personnel.
We recommend that either a Dräger Safety training course or a DrägerService service
contract be obtained and that all repairs are carried out by DrägerService.
Refer to EN 50073 and/or local regulations.
Concerning transmitter or measuring head operation and maintenance, refer to the
transmitter operating manual or to the measuring head information.
WARNING!
Not for use in areas where explosion hazards are possible
This device is not approved or certified for installation in
potentially explosive atmospheres.
Liability for proper function or damage
Liability for proper function of the device is irrevocably transferred to the owner or
operator to the extent that the equipment is serviced or repaired by personnel not
employed or authorised by DraegerService, or if the equipment is used in a manner not
conforming to its intended use.