PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
6 - 3
2. Dry with a clean cloth or paper towel.
Cleaning Metal Surfaces
WARNING:
The heater assembly may be hot enough to cause burns. Before cleaning or touching the
warmer head, allow 30 minutes for the unit to sufficiently cool after removing power from the
unit. Failure to do so could result in personal injury.
CAUTION:
Avoid cleaning metal surfaces with products containing bleach type cleaners which are
corrosive to metal surfaces. Failure to do so could result in equipment damage.
Use disinfectant-detergent, such as cold sterilants and quarternary ammonium compound disinfectants to
clean all surfaces thoroughly. Make sure to clean all holes and indentations, and then dry with a clean
cloth or paper towel.
Cleaning Wood Surfaces
Use a disinfectant-detergent to clean all surfaces thoroughly, and then dry with a clean cloth or paper
towel.
Cleaning the Reusable Skin Temperature Probe
WARNING:
Disposable probes are for single-patient use and should be disposed of after use. Failure to do
so could result in infant injury.
CAUTION:
Do not pull on the tip of the skin temperature probe when cleaning or drying. Probe damage
could occur.
Use a disinfectant-detergent to clean all surfaces thoroughly, and then dry with a clean cloth or paper
towel.
Cleaning the Reusable Suction Bottle
Discard the filter and tubing. Use disinfectant-detergent, such as cold sterilants and quarternary
ammonium compound disinfectants to clean all surfaces thoroughly. Make sure to clean all holes and
indentations, and replace the air filter after each patient use.
To Next Page
Loading...
