Dräger RW82 - Troubleshooting

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
7 - 1
Section 7
Troubleshooting
Troubleshooting
WARNING:
Only facility-authorized personnel should troubleshoot the Resuscitaire Radiant Warmer
products. Troubleshooting by unauthorized personnel could result in personal injury or
equipment damage.
For troubleshooting of the equipment, refer to the table on page 7-1 and to the table on page 7-3. If you
cannot localize the fault, remove the unit from use, and refer it to factory-trained or other qualified
service personnel.
Troubleshooting
Symptom Possible Cause Corrective Action
There is no power, and the
Power Fail alarm does not
activate.
The circuit breaker on power
input is not set to ON.
Set the circuit breaker to ON.
Allow the warmer to run with
power ON for > 3 min to charge
the supercap.
The Power Fail alarm activates. The circuit breaker on power
input is tripped.
Reset the circuit breaker.
The power cord is unplugged. Plug the power cord into the
POWER connector on power
input.
The power cord is damaged. Replace the power cord.
The System Fail alarm activates.
An error code appears.
There is an internal malfunction. Refer to “System Fail Error
Codes” on page 7-3, or refer the
unit to service.
The System Fail alarm activates.
No error code appears.
There was a prolonged brown-
out.
This alarm is not resettable.
Refer the unit to service.
The Probe Fail alarm activates. The skin probe is disconnected. Connect the skin probe to the
infant’s skin. If the skin probe is
plugged into the probe recepta-
cle, the tip of the probe must be
in contact with the infant’s skin.
If not, remove the skin probe.
The skin probe is damaged. Ensure that the skin probe is in
good contact with the skin. If the
problem still exists, replace the
skin probe, then refer the unit to
service.