Dräger X-am 5100 - Page 9

Use
Dräger X-am 5100 9
3.1.5 Before entering the workplace
1. Switch on the instrument. The current measured values are
shown in the display.
 Observe any warning » « or fault messages » «.
2. Check that the gas inlet opening on the instrument is
not covered.
WARNING
Before safety-related measurements, check the
calibration and recalibrate if necessary. A bump test
must be carried out in accordance with the national
regulations.
The instrument can be operated normally. If the warning
message does not disappear automatically during
operation, the instrument must be serviced after the end
of use.
The instrument is not ready to measure and requires
maintenance.
!