Draytek Vigor2830 Series - Page 332

Vigor2830 Series User’s Guide
320
remote PC through Samba service.
IP Address
If you choose VNC or RDP, you have to type the IP address
for this protocol.
Port
If you choose VNC or RDP, you have to specify the port
used for this protocol. The default setting is 5900.
Idle Timeout
If you choose VNC, you have to specify the time for
disconnecting the SSL VPN tunnel.
Scaling
If you choose VNC, you have to choose the percentage
(100%, 80%, 60%) for such application.
Screen Size
If you choose RDP, you have to choose the screen size for
such application.
Samba Path
If you choose Samba, you have to specify the path of the
Samba service.
3. Enter the required information.
4. After finished the above settings, click OK to save the configuration.