HYDRAULIC TORQUE CONVERTER SECTION 7B
Page 25
DRESSTA TD-25M EXTRA
TORQUE CONVERTER
25. Install shims pack (34) on the outer race
of bearing (31). Install housing cover (35),
secure with the bolts (35A) and washers
(35B). Apply LOCTITE #243 to the bolts
and torque to 48 ÷ 58 [Nm].
NOTE: Make sure the shims forming the pack
are centrally placed on the bearing outer race
so none of them will get clamped between the
housing cover and the drive housing.
NOTE: Remove eyebolt (U) prior to torque
converter machine installation.
26. If gear ring (36) was replaced, install new
gear ring (36) to flywheel and secure with
bolts. Apply LOCTITE #243 to the bolts
and torque to 83 ÷ 101 [Nm].
To Next Page