INTRODUCTION SECTION 1
Page 11
DRESSTA TD-25M EXTRA
SAFETY PRECAUTIONS
When the machine is to be loaded onto a transport truck and trailer do so carefully. Load only
when the trailer is level. The steel track shoes will slide easily on the trailer. When the machine is
properly positioned tie it securely with a rope and block with wooden pieces so it cannot move on
the trailer. For more detailed information refer to OPERATOR”S MANUAL.
Keep your head, body, legs, hand, fingers away from the blade and ripper when they are in
a raised position.
Do not allow the hydraulic system to support the mounted equipment without its proper blocking
when leaving the machine unattended, to eliminate the possibility of an expected drop of the blade
or ripper.
SERVICE INFORMATION
6. SERIAL NUMBERS
For complete description and location of the machine serial number, the blade serial number, the
ripper serial number and the engine serial number, refer to SECTION 1, INTRODUCTION in
OPERATOR’S MANUAL.
All other components having serial numbers are each equipped with a separate stamped serial
number plate.
Use machine serial numbers when requesting information or ordering parts and proper numbers
from PARTS CATALOGUE.
7. INSPECTION AND REPAIR
Bearings
Inspect for evidence of overheating, cracks, scores, pitting and general wear and replace
if necessary. Serviceable bearings must be cleaned, soaked in fresh lube and wrapped in grease
proof material.
Gasket and Seals
Always use new gaskets and seals during assembly and installation. Use extreme caution to avoid
damage to seals or gaskets during these operations. Use sleeves or tape when seals have to be
passed over threads or splines. Pack lip type seals with fresh grease prior to installation. Felt dust
seals must be soaked in light clean oil before assembly.
DO NOT roll an O-ring during installation. To correctly install, position at one point and using
a blunt tool, stretch into position. DO NOT stretch any more than is required for proper installation.
To Next Page