DriSteem RL-3 - Unpacking the Dehumidifier

8
DEHUMIDIFIER INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
UNPACKING THE DEHUMIDIFIER
Disassemble the carton, but leave the unit attached to the
pallet for installing the unit with a forklift or scissors lift.
IMPORTANT:
• For Models RL-3, RL-4, RL-6, and RL-9, cut the strap
securing the compressor shipping support bracket and
remove the strap and shipping bracket. Reinstall screws
for RL-6 and RL-9. See Figures 8-1 and 8-2.
Unpacking the dehumidifier
90-1908
OVERVIEW
FIGURE 8-1: MODELS RL-3 AND RL-4 REMOVE SHIPPING
BRACKET
90-2013
FIGURE 8-2: MODELS RL-6 AND RL-9 REMOVE SHIPPING
BRACKET
Remove shipping bracket
Cut off
plastic
strap
Remove screws (2), discard
shipping bracket, reinstall
screws (2)
Cut off
plastic
strap